Your cart is empty.
Your cart is empty. Module highlights:
1. Adopt the dual MOS parallel active output, lower internal resistance, larger current and strong power,
at room temperature 15A, 400W, which meets the use of most equipment;
2. Wide voltage, perfect support for PWM;
3. Easily realize the control of high-power equipment.
Product parameters and application:
4. Working voltage: DC 5v-36v;
5. Trigger signal source: digital high and low level (dc3.3v --20V), can connect microcontroller IO port,
PLC interface, dc power supply, can connect signal, signal frequency 0--20KHZ perfect support.
6. Output capacity: DC DC 5v-36v, room temperature continuous current 15A, power 400W!
Under the condition of auxiliary heat dissipation, the maximum current can reach 30A.
7. Application: The output end can control the high-power equipment, motor, bulb, LED light belt, dc motor,
miniature water pump, solenoid valve, etc., control the motor speed, the brightness of the lamp, etc.
8. Service life: unlimited switch;Operating temperature: -40-85 ℃;Size: 3.4 * 1.7 * 1.2 cm
Package Including:
10 x MOS FET Trigger Switch Drive Module
The board is of high power MOS trigger switch driver module and control board with field-effect tube to
adjust the electronic switch. It adopts double MOS parallel active output to show lower internal resistance,
greater electric current and power. Besides it works at 15A,400W under common temperature which satisfies
most devices usage and realizes the control of great power devices in a relaxed way. What’s more,
it can be applied to powerful devices which could be controlled by output terminal like electric motors and light bulbs
to control the speed of motor and the light of bulbs. Certainly,you can apply it to devices which could input
for control like LED light belt,DC motor,Micro pump and solenoid valves.
Some guy on the Internet
Reviewed in the United States on March 4, 2021
These work great, I'm using them in an unconventional way, to trigger buttons on an RF fan remote control from an Arduino based home automation system. They basically act like relays, but without the annoying clicking sounds. Know that the switched side (screw terminals) also requires a common GND to your Arduino GND. So not true isolation like a relay or optocoupler, but for a remote control which runs on batteries anyway, and uses a common Ground between all the buttons, not a problem.
Cody
Reviewed in the United States on March 11, 2021
The amount of current these can handle is excellent. From many sources, they can actually handle a lot more if you use some passive heat dissipation. I haven't tried them passed their spec, but I could see that being the case. I use them for powering many different devices and have had zero issues. The cost per number received is excellent as well.
Mr. Neil Ives
Reviewed in the United Kingdom on January 10, 2021
I used one between an Arduino Nano and a solenoid
K. Orrall
Reviewed in the United States on April 11, 2021
Consistently burn out with a 36 watt load, They burn out within 5 minutes. If I add a make shift heat sink directly on the mosfets they last about 30 minutes.
Mr. Wizard.
Reviewed in the United Kingdom on September 26, 2020
These circuit boards work ! , Carry a higher current load by small negativeinput circuit ,which in my case was a flip- flop circuit.
RM
Reviewed in the United States on November 3, 2020
When I opened the package, I was pleasantly surprised to find each board was individually wrapped in an antistatic bag and packaged in a larger resealable antistatic bag.The soldering is excellent. The overall quality of the product is a lot better than I expected.I tested a single board and it worked as expected. I would recommend this without any reservation.
Recommended Products
