Your cart is empty.
Your cart is empty.You are buying 10 (Ten) NEW 1/8" DIAMETER by 12" LONG CLEAR EXTRUDED ACRYLIC RODS. They are 3.175MM diameter. (Eighth inch Diameter x Twelve inch Long) You will receive TEN 1/8" diameter x 12" Long solid clear rods. To assure that you get the finest quality, the protective sleeve is kept in place on the rods while being cut to protect the acrylic. All rods have saw cut edges on both ends. Saw cutting might cause micro chipping on the ends of the rods as seen in the pictures. Please allow a tolerance of +/- 1/16" on all pieces.
Wayne A Christensen
Reviewed in the United States on April 1, 2022
Transmits light perfectly.
Sara H.
Reviewed in the United States on June 23, 2021
These are crystal clear! I bought them to use as supports for my orchids. Not too stiff, not too weak; just perfect! I don't like the way wooden sticks start to get moldy, so these were perfect! I used the heat from a flame to gently soften the stick to match the curvature of the branch on my orchid... absolutely perfect and kept its clarity!
John B
Reviewed in the United States on June 11, 2021
Item was as described and shipped on time.
C.M.
Reviewed in the United States on October 17, 2021
Bought it to replace 2” & 3” 3mm pegs for 25mm & 30mm stands, with 3mm holes in the center. I wanted to have asteroids, ships, debris, space stations, 40k and Legion figures at different, various heights. These are easy to cut to 4”-6” lengths and they fit perfectly into stands with existing 3mm holes. I’m very with these.
CHaughton49
Reviewed in the United States on May 15, 2020
I used these to make centerpiece decorations and they were exactly what I needed. They come wrapped in plastic so they were in perfect condition when I opened them. I will use these again for sure!
Reader X
Reviewed in the United States on February 26, 2020
10 1/8" diameter by 12" long clear plexiglass rods. Neatly packaged in a round crush-resistant container, and quickly delivered.
Maria Alejandra
Reviewed in the United States on October 10, 2020
It is exactly what I needed for my project.
Terry E Steffensen
Reviewed in the United States on November 7, 2019
Parts were supposed to be 1/8", .125". Most were anywhere from.131" to .120". So they either fell through or would not go into a .125" hole. Could only use about1/3 of the parts
Recommended Products
