Your cart is empty.
Your cart is empty.Since 1983 Belltech engineers developed one of the industry firsts that enabled the Sport Truck craze, the Belltech Drop Spindle. By relocating the wheel mounting point a.k.a. spindle pin or hub higher on the spindle casting, our engineers were able to provide a 2-3" lowering without affecting any other suspension or steering geometry. Belltech Drop Spindles offer a 2 or 3 inch drop depending on the application, while improving handling and retaining factory ride quality. Belltech spindles maintain critical suspension geometry and eliminate excessive ball joint, shock and tire wear common to other methods of lowering. Each spindle is built from OEM grade high strength ductile iron, providing the structural integrity to meet and exceed all factory specifications & requirements.
marc kalanuk
Reviewed in Canada on October 30, 2024
Were used spindles, sharfs were irregular size dis not fit. Waste of time and money. Dis not get a full refund
Mason g
Reviewed in Canada on June 13, 2022
Fit my 81 with 1” rotors, was concerned my Aluminum American Racing 15”x 7” rims would not fit , minimal lower control arm grinding done, end result Rims had enough clearance 0 issues, (followed Belltech reminders , bend brake line, grind lower control arm) sitting low , handles great and happy I went with Belltech ,
Canmmc
Reviewed in the United States on January 28, 2019
1986 Chevy C10.1st set of spindles showed up and they looked like they were used. Further inspection showed that one of the spindles was cracked by the brake caliper mounting hole. Sent them back and got a replacement set ordered with no issue.Got the second set a little over a week later and they arrived in better condition. Driver's side went on with no real problem. Got the passenger side all bolted up and couldn't get the brake caliper to mount up. Looked it over and found that the top caliper bracket wasn't machined correctly from the factory. It was too fat and the brake pads wouldn't slide in. I had to get out the angle grinder and shave off about 1/4" of the top tab to make it the same as the bottom.Overall pretty disappointed with the Belltech spindles.Finished product looks pretty good though!
Cas Breland
Reviewed in the United States on August 15, 2016
Had some trimming to do on the control arm and needed to bend the brake cable but are working well on my 1984 GMC 1500.
steven reed
Reviewed in the United States on February 11, 2015
Does this fit a 1985 chevy half ton 2 wheel drive ?
Recommended Products
