Shopping Cart

Your cart is empty.

Your cart is empty.

Crown Automotive Crankshaft Position Sensor Grommet Ignition

Free shipping on orders over $29.99

$6.30

$ 2 .99 $2.99

In Stock
  • Direct Replacement
  • High quality construction
  • Top quality products
  • Enhance the style, comfort and functionality of your vehicle
  • Durable and long lasting


Crown Automotive carries over 9600 unique quality replacement parts encompassing over 766,000 different applications for every model of Jeep produced since 1941.


Mike L.
Reviewed in the United States on March 29, 2025
100% does not fit a 2000 Jeep cherokee 4.0 4x4.
greene91
Reviewed in the United States on February 19, 2025
Glad they sell this, mine was falling apart.
john w Trudo
Reviewed in the United States on June 16, 2024
This was the Hardest part of the job to get on it was tight but after struggling it went in and sealed up the bell-housing hole. Its Made of a molded Plastic and not Rubber like the original but hopefully will hold up a long time.
Ryan Pope
Reviewed in the United States on May 21, 2024
It's not the seller's fault, must be model-to-model variability. It was too long for my 2001 Jeep Cherokee.
Hotbuddha
Reviewed in the United States on June 23, 2019
This part is also known as a camshaft position sensor grommet. Hint hint seller, that's what everyone calls it so put that in the title or something so people can find it. It fits TIGHT and it'll be a pain to install UNLESS you pinch it from top to bottom kind of hard so it curves upwards, then it will pop right in. Once in the part will settle back to original shape and fit super tight.
Tim Mende
Reviewed in the United States on December 29, 2019
Plugged up the sensor hole in the bell hosing left by the decrepit crumbling original on my ‘91 YJ
Rod Clark
Reviewed in the United States on March 5, 2018
I ordered this part when I noticed mine was missing off my 91 Jeep YJ. The part was a little difficult to install until I used my heat gun to soften it and then it snapped in for a perfect fit. It is a definitely a necessary part to keep foreign particles out of your bell housing.
Jhearty88
Reviewed in the United States on October 27, 2018
Listed to fit my 94' Cherokee but its way smaller than the factory gromet, leaves a gap than you can put a finger in . id stay away from this and crown products in general, haven't had much luck with their stuff at all.I included a picture of the mopar grommet compared to Crowns replacement.