Your cart is empty.
Your cart is empty.Product Description
SUITABLE:
ONLY compatible with 1/10 Traxxas 2WD Slash, Stampede, Stampede VXL, Slash VXL, Rustler, Rustler VXL, Ford F-150 Raptor RC vehicle
MATERIAL:
Red-anodized 6061 aluminum alloy, lightweight and durable
Worked Great:
Include necessary parts required for installation, multi-hole design, adjustable tie rod angle can be used for Traxxas Slash 2WD Caster Block
YOU WILL RECEIVE:
- 2× Rear Stub Axle Carriers
- 2× Steering Block
- 2× Caster Blocks (L/R)
- 6× Screw Pins
- 2× Screw
- 8× bearings 5x11x4mm
- 4× Gasket
Patricia Stange
Reviewed in the United States on January 24, 2024
The bearings either didn't fit because it was to tight or they just fell right out,waste of money
JayG
Reviewed in the United States on April 22, 2024
The kit comes with no instructions and a bunch of parts. There are extra washers but they appear to be the wrong diameter. If used - these would likely close the gap and prevent the slop. Unfortunately, they are the axle washers that go on the outside of the bearing race. I used some small washers installed and it tightened it up a bunch. I had to replace one side due to a crash/bracken spindle arm. These were so sloppy I had to disassemle and add washers to tighten it up.I'd say the tolerances aren't super tight - a plastic or delrin bushing would be nice to mitigate the slop. I have it working, but see room for improvement.5/6/24: Rev B - Been using these and not a huge fan... There is way more slop than the OEM plastic, the wheel was flopping around and I had to remove the washers as it was causing my steering servo to bind. I ended up removing these and installing the Traxxas OEM ones. The tolerance is better than these - supply some of the approriate size delrin/teflon bushings/washers if you need to tighten it up. You can buy varying thickness washers online and at hobby shops - too much work for something I want to drive and not spend forever trying to tweak. In retrospect - the OEM plastic was ok, RPM has a tad too much flex, these had too much slop, the Traxxas aluminum are same as OEM with the slightest tolerance which is tighter than these... Sorry folks - they work, just a tad sloppy. The design of the front pin isn't setup to sandwich the metal and tighten the tolerance some - you screw the pin in and the threaded end is near the head. That means a pin through and retained at head - no way to tighten...
(joe kail) joesatellite
Reviewed in the United States on August 7, 2023
The media could not be loaded.
J dude
Reviewed in the United States on April 27, 2023
Parts arrived with oversized holes for the pins. Super sloppy and unusable.
Campbell Pritchard
Reviewed in the United States on April 24, 2023
Had a difficult time with alignment on rear hubs. Camber was off. Hardware is sub par and immediately stripped out.Update, machining is not within tolerance, all parts fit so loosely that the truck shakes and does not handle well due to shaking. Not a great product, I’d like my money back.
Recommended Products
$99.99
$ 48 .99 $48.99