Your cart is empty.
Your cart is empty.The Micro Jig MATCHFIT Relief Router Bit is specifically designed to remove 55% of waste material before routing dovetail grooves with the MATCHFIT Dovetail Router Bit. Starting with a relief groove improves the cut quality of dovetail grooves, and prolongs the lifespan of your MATCHFIT Dovetail Router Bit. Designed to be used with MATCHFIT Dovetail Router Bit. Features tear out-free 1/4 relief groove, 11/32" laser-cut depth guide router collet safety line and 1/16top radius, 3-degree up shear carbide. MATCH FIT Dovetail Router Bit is sold separately.
Graham T.
Reviewed in Australia on March 12, 2024
As I have found with all Matchfit products, the quality is second to none.
Hokie1969
Reviewed in the United States on December 3, 2024
I have cut many dovetail grooves since getting the Matchfit system and even though I am using a 3 1/2 HP router this bit sped up the process and reduced all drag on the dovetail bit. Glad I purchased it.
Customer
Reviewed in the United States on July 17, 2022
Product is as described. Looks to be good quality
BCoop
Reviewed in the United States on March 6, 2022
This bit provides a much cleaner cut than a straight end mill. Highly recommend
Thomas B.
Reviewed in the United States on January 17, 2022
Could you use a 1/4” straight bit that’s already in your shop? Yes. This bit has a shear angle on the cutters and slight round over on the shoulders that sets you up for best results when making final pass with MatchFit dovetail bit. Have only made two jigs in 3/4” plywood with this pair of bits and so far I’m impressed. Bit of blow out at ends of cuts (did not use backer board), but tops of grooves are clean. MatchFit’s bit are well made and perform well. Bottom line is you can make relief cuts with ordinary bits or even on a table saw, and you don’t absolutely need MatchFit’s dovetail bit either. But if you plan to make a lot of jigs and fixtures with this system, then getting the matched dovetail and relief bit may make sense for you.
craig lindquist
Reviewed in the United States on August 21, 2021
This is a Preston product , well designed.
Andrew Stone
Reviewed in the United States on March 3, 2021
Nice router bit. Make sure its partner (dovetail bit) doesn't get lost in the mail. Can't return what you don't have. ;-)
Kenny
Reviewed in the United States on December 6, 2021
Make slots for Microjig router dovetail bits to rout out dovetails for Microjig clamps. I.E., to allow two routing passes for dovetail bit durability. Using this bit first makes it easier on the dovetail bit.
Durango Pat
Reviewed in the United States on December 21, 2021
Works great and I like the slight round over. Then I switch over to the dovetail bit
Recommended Products
